Wheels, Tires, Driveshaft

These longer-than-stock 45mm wheel studs are sold in sets of five and are perfect if you're running wheel spacers. Please note whenever changing the length of studs, you must confirm that the nut does not bottom out on the stud before it tightens the rim...

This front outer wheel bearing fits 1985-91 2WD and later 1984 Vanagons. Fitment Note:  According to Volkswagen, this bearing will fit from chassis number 24-E 023828, but in some cases, we have found this to be incorrect. The best way to check is...

These hub caps are for the factory 14-inch alloy rim. It is our opinion though that the color is just slightly darker than the originals, but the fit is excellent and these are the only game in town. Sold individually. Ref ID: 251601171

This 46mm rear axle nut is CRITICAL to the rear drivetrain of your van or bus! Without proper torque of 360 ft/lbs, this nut can come loose and ruin your day. Fits all Vanagon models 1980-91 Fits all bay window bus models 1968-71 Fits split window bus...

Early front outer wheel bearing. Fit all 1980-83 Vanagons and early 1984. Note: According to Volkswagen, this bearing will fit up to chassis number 24-E 023827, but in some cases, we have found this to be incorrect. The best way to check is to measure...

M8 triple square drive bit for 3/8" drive socket wrench. Please check your CV bolts before ordering as some vehicles can have 12 point bolts or 6-point bolts. Also sometimes referred to as a "triple-square bit". Please click here for the 12-point tool...

This center cap fits any of our Eurolook alloy wheels. Fits both 15" and 16" sizes Silver in color Easy installation  

Six-point 6mm hex drive socket for use with aftermarket Vanagon CV bolts.   NOTE: Original CV bolts had 12-point socket heads.  We offer this tool to use if someone has replaced the original 12-point bolts with 6-point.  We feel that...

This circlip secures the rear wheel bearing in all models of Vanagon and Bay window bus. Fits 1968-1991 Sold individually.Ref ID: N0122951 Shop by Diagram Hover over the icon and click to get the detail.  

This boot is used on all vans including Syncro for the rear axles. In a pinch, it can be used for the Syncro front inner, but we prefer to use the stock Syncro Front Boot Kit in conjunction with the stock Syncro flange or the Rockford boot. In our...

Replacing this front locking axle nut when you replace your rotor or wheel bearings is cheap insurance.  This nut is peened with a hammer and small punch during installation.  Repeated re-use of old nut weakens its shoulder, causing it to...