Manual Transmission

This washer/plate spreads the clamping force on the plastic cap located on the transmission behind the drive flanges.  The plastic cap locks the side screw adjusting ring into place. Fits all manual transmission Vanagons including Syncro. Also fits...

This Timing Hole Cap with Strap fits the hole in Bell Housing on all 1980-91 aircooled and watercooled Vanagons.  It's also used in conjunction with the diesel bell housing timing hole plug.  Ref ID #020301132

This plastic base for the Vanagon shifter is available individually, but is included in our complete shifter base kit. Shop by Diagram Hover over the icon and click to get the detail.   Ref ID: 171711227A

This is the o-ring that goes between the transmission housing and the reverse light switch housing. Fits 1983.5-1991 vans both 2WD and Syncro. Ref ID: 094301278A

Factory roll pin that secures the shift selector lever to the shift selector shaft on the transmission. Removal of this pin is required to remove the lever when replacing the seal.   Fits 1983-1991 2WD and Syncro Vanagons with manual...

This transmission side cover o-ring seals the side cover to the body of the transmission. We've found that the vast majority of transmission fluid leaks from the side of the trans are from the flange cap (leaks into the CV) or drive axle seal (leaks down...

This is the fastener for the plastic lock plate that locks the transmission sidescrew adjusting ring. Fits all manual transmission Vanagons including Syncro. Two per cap, four per van.  Sold individuallyAlso fits Type 2 bus 1968 thru 79. Ref ID:...

This circlip secures the shift rod selector shaft.  It lives on the opposite side of the transmission case from the shift lever. Fits 1983.5-91 2wd & 4wd Vanagons with manual transmissions. Please click here for the shift rod selector shaft...

This is the universal shift joint o-ring for gear selector. Please click here for the circlip. Fits all Vanagon's with manual transmissions from mid-1983-91. Four per van, sold individually. Ref ID: N90089901 Shop by Diagram Hover over the icon and click...

This circlip pulls double duty in the Vanagon. It secures the hatch strut to the body of the van. It also holds the pins in the shift selector shaft to the shift linkage universal joint. Fits 1980-91. Sold individuallyRef ID: N0124362