Front Suspension Parts

Our radius arm nut kit contains the nuts for the radius arm shaft that retains bushing to the subframe. This will fit both 2WD and Syncro applications. One nut is a lock nut and one is a non-locking nut. The non-locking nut goes on...

These are quality bushings that go between end-link and control arm for late 1985-91 2WD Vanagons There are four per Van, sold individually. For the urethane version please click here. Ref ID: 411513121

This rubber bushing connects the 19mm front sway bar to the end link. Sway bars came in both 19mm and 21mm sizes.  It's easy to check which size your van has by hopping under the front of your van with a 19mm open end wrench.  If the open end...

This rubber bushing connects the 21mm front sway bar to the end link. Sway bars came in both 19mm and 21mm sizes.  It's easy to check which size your van has by hopping under the front of your van with a 19mm open end wrench.  If the open end...

This steel sleeve centers and supports the bushings on the drop link. One per side, two per van. Ref ID: 251411047   Shop by Diagram Hover over the icon and click to get the detail.  

 This nut attaches the rear trailing arm in 1980-91 Vanagons. Fits both 2WD and Syncro. Four per van, sold individually. Ref ID: N10105507

This upper control arm washer lives under the upper control arm nut that affixes the arm to the chassis. Fits all vans 1980-1991.  Two per van, sold separately. Please note that these are not the eccentric washers that are on the control arm bolts...

Replacing this front locking axle nut when you replace your rotor or wheel bearings is cheap insurance.  This nut is peened with a hammer and small punch during installation.  Repeated re-use of old nut weakens its shoulder, causing it to...

Rear control arm bolt washer. Fits all years and configurations of the VW T3 Vanagon. Eight washers per vehicle. Sold individually. Ref ID: 481501543

This eccentric washer is used to align the front suspension in Syncro Vanagons.  It is used in conjunction with the upper control arm bolt to set the camber in the front end. The width of the space this washer sits in is critical for the alignment...

This eccentric washer is used to align the front suspension in Syncro Vanagons.  It is used in conjunction with the upper control arm bolt to set the camber in the front end. The width of the space this washer sits in is critical for the alignment...