Go

1986-1991 T3 Vanagon

The 1986-1991 VW T3 Vanagon featured a refined 2.1L engine while retaining the great drivability of the earlier vans. Whether in passenger, pickup or camper form, the Vanagon is ready for any task or adventure. Van Cafe has the replacement parts and upgrades to keep your van heading down the highway!

Sidebar Sidebar Sidebar
  • Rear CV Boot Small Clamp
    Add to Cart The item has been added

    Rear CV Boot Small Clamp

    Small rear CV boot clamp. Although this clamp comes in the CV joint and boot kits. Here they are individually. Ref ID: 113501159B
    $1.29
    SKU: 001728
    Add to Cart The item has been added
  • Water Pump To Side Pipe O-Ring
    Add to Cart The item has been added

    Water Pump To Side Pipe O-Ring

    This O-ring sits in a groove on the water pump to seal the stainless pipe that comes off the water pump and heads around the drivers side of the engine toward the thermostat housing. When you buy a new water pump for your 86-91 van, this O-ring is...
    $1.25
    SKU: 001495
    Add to Cart The item has been added
  • Coolant Level Sensor O-Ring
    Add to Cart The item has been added

    Coolant Level Sensor O-Ring

    Quality rubber O-ring for coolant level sensor. Fits all 1.9L- and 2.1L-powered Vanagons. Note: if you are purchasing a new level sensor from Van Cafe, we already include an o-ring. Ref ID: N90240002
    $1.24
    SKU: 003580
    Add to Cart The item has been added
  • Flywheel & Flex Plate Bolt
    Add to Cart The item has been added

    Flywheel & Flex Plate Bolt

    These bolts attach the flywheel or flex plate to the crankshaft. Five used per application, sold individually. If you need the flywheel o-ring, please click here. Ref ID: N90226801 Shop by Diagram Hover over the icon and click to get the detail.  
    $1.24
    SKU: 003579
    Add to Cart The item has been added
  • Rear Axle Nut Cotter Pin
    Add to Cart The item has been added

    Rear Axle Nut Cotter Pin

    This cotter pin acts as a safety in case the rear axle nut comes loose.  It is ESSENTIAL that you install this cotter pin after you torque your axle nut to 360 Ft/lbs of torque. Fits all Vanagon models 1980-91 Fits all bay window bus models...
    $1.24
    SKU: 003502
    Add to Cart The item has been added
  • Water Pump Pulley Bolt
    Add to Cart The item has been added

    Water Pump Pulley Bolt

    Water pump pulley bolt.  There are three of these that hold the pulley to the water pump on WBX 1.9L and 2.1L motors. M8 x 1.25 x 16 Sold individually.
    $1.24
    SKU: 000838
    Add to Cart The item has been added
  • Windshield Washer Pump Grommet
    Add to Cart The item has been added

    Windshield Washer Pump Grommet

    Windshield washer pump grommet for the front or rear washer pump on all vans. If you need the pump, please click here . You will use one grommet for the front pump and one grommet for the rear pump. Sold individually. Ref ID: 443955465
    $1.19
    SKU: 002757
    Add to Cart The item has been added
!