Go

1986-1991 4WD T3 Vanagon Syncro

The original 4WD campervan! Vanagon Syncros are rugged, capable off-road machines and Van Cafe has ALL the parts for upkeep and upgrade. We manufacture bumpers and body protection, swingouts and storage. Home of the DIY Subaru conversion!

Sidebar Sidebar Sidebar
  • Transmission Selector Shaft Seal
    Add to Cart The item has been added

    Transmission Selector Shaft Seal

    If you have transmission fluid leaking out of the side of the trans at the selector shaft, this is the culprit. You remove the shift lever with the ball attached. You will find it easier to remove the shaft than to try to replace the seal with the shaft...
    $5.95
    SKU: 001288
    Add to Cart The item has been added
  • 30A Fuse Holder with Cap
    Add to Cart The item has been added

    30A Fuse Holder with Cap

    30A Fuseholder for ATF/ATO Type Full Size Blade Fuses. To install: The terminals must come back into the housing AFTER crimping. Insert the wires through the seal and housing Crimp on the terminals Pull the wires back into the housing Push the seal...
    $5.81
    SKU: KT-000874
    Add to Cart The item has been added
  • Intake Manifold Hose - 2.1L Intake Manifold Hose - 2.1L
    Add to Cart The item has been added

    Intake Manifold Hose - 2.1L

    High quality version of the original rubber intake manifold hose on the 2.1L 1986-91 Vanagon.  These hoses are a very common cause of intake leaks causing rough idle or a lean running condition. There are four used per van.  Sold individually...
    $5.49
    SKU: 003584
    Add to Cart The item has been added
  • Skylight Knob - Beige Skylight Knob - Beige
    Add to Cart The item has been added

    Skylight Knob - Beige

    Westy Skylight knob in beige for brown interiors.  Simple one-screw installation. Replace that nasty knob in your Westy today!This item not subject to discounts.Ref ID: 253070937A
    $5.49
    SKU: 002458
    Add to Cart The item has been added
  • Catalytic Converter Plug
    Add to Cart The item has been added

    Catalytic Converter Plug

    M18 x 1.5 mm test plug for our catalytic converters.  Use this plug if you are NOT using an oxygen sensor in the catalytic converter.  Fits both CARB-compliant and Federal-standard emissions catalytic converters.
    $5.14
    SKU: 000700
    Add to Cart The item has been added
  • Rear Seat Heater Core Bleed Screw O-Ring Rear Seat Heater Core Bleed Screw O-Ring
    Add to Cart The item has been added

    Rear Seat Heater Core Bleed Screw O-Ring

    This o-ring seals the bleeder screw on the rear seat heater core.  Why buy an entire bleeder screw when perhaps all you need is a new o-ring? Ref ID: 861819039 Shop by Diagram Hover over the icon and click to get the detail.  
    $5.14
    SKU: 002970
    Add to Cart The item has been added
  • 6 Point Hex-socket for Aftermarket CV Bolts
    Add to Cart The item has been added

    6 Point Hex-socket for Aftermarket CV Bolts

    Six-point 6mm hex drive socket for use with aftermarket Vanagon CV bolts.   NOTE: Original CV bolts had 12-point socket heads.  We offer this tool to use if someone has replaced the original 12-point bolts with 6-point.  We feel that...
    $4.95
    SKU: 001276
    Add to Cart The item has been added
  • 9-Pin Relay Holder
    Add to Cart The item has been added

    9-Pin Relay Holder

    This relay holder is specifically for the special nine pin relays in your Vanagon. Comes complete with nine new metal pins.Ref ID:251937501
    $4.95
    SKU: 002365
    Add to Cart The item has been added
  • Base For Sliding Door Grab Handle Base For Sliding Door Grab Handle
    Add to Cart The item has been added

    Base For Sliding Door Grab Handle

    This base for the sliding door grab handle is specifically contoured to match the angles on the body where the handle mounts.  You'll need two bases per handle. Black in color. Note: This will not fit the A-pillar grab handle in the front cab...
    $4.95
    SKU: 002553
    Add to Cart The item has been added
!