Shift Components

This is the style that does not accept boots but has the double lip seal that keeps dirt out and grease in. It is used as the front bushing near the gas tank in all water cooled gas models (the one in that location tends to not wear as much) as well as...

Shift rod/selector shaft cover gasket. Fits 83.5 thru 91. If you need the cover, please click here.Ref ID: 091301278B

Currently available individually, but is included in our complete shifter base kit. Shop by Diagram Hover over the icon and click to get the detail.   Ref ID: 171711227A

This universal shift joint for gear selector. Fits all Vanagon's with manual transmissions Mid-83-on. Please click here for the o-ring and here for the circlip. Ref ID: 251711551 Shop by Diagram Hover over the icon and click to get the detail.  

If you have transmission fluid leaking out of the side of the trans at the selector shaft, this is the culprit. You remove the shift lever with the ball attached. You will find it easier to remove the shaft than to try to replace the seal with the shaft...

This is the bearing/bushing that the shift rod goes through and it sits behind the transmission selector shaft seal. Fits 83.5 thru 91. It has come to our attention that all of the shift rod bushings on the market may have been made with the...

This is the small stop cap for the shift rod that is on the other side of the transmission case from the shift lever. Fits 83.5 thru 91 2wd and 4wd. Please click here for the circlip or spring. Ref ID: 091301267

This is the large spring for the shift rod that is on the other side of the transmission case from the shift lever. Fits 83.5 thru 91 2wd and 4wd. Please click here for the circlip. Ref ID: 091311548B

Shift lever bushings. Fits all manual transmission Vanagon except for the rare 5-speed models. Sold as pair- Quantity "1" will yield 2-bushings If you need the complete kit that includes the special bolt and the lock nut, see our Shift Lever Bushing...

Factory roll pin that secures the shift selector lever to the shift selector shaft on the transmission. Removal of this pin is required to remove the lever when replacing the seal.   Fits 1983-1991 2WD and Syncro Vanagons with manual...

This circlip secures the shift rod selector shaft.  It lives on the opposite side of the transmission case from the shift lever. Fits 1983.5-91 2wd & 4wd Vanagons with manual transmissions. Please click here for the shift rod selector shaft...