Front Suspension Parts

Drop link bushings to replace old dried up ones. These are made in Germany, sold individually. 2 per van. If you would like a 19mm urethane bushing please click here. Ref ID: 251411045B Shop by Diagram Hover over the icon and click to get the detail...

These are made in Germany, sold individually. If you would like the 21mm urethane version bushing please click here. Ref ID: 251411045 Shop by Diagram Hover over the icon and click to get the detail.  

2 per van. Sold individually. This Sleeve goes between drop link bushings Ref ID: 251411047   Shop by Diagram Hover over the icon and click to get the detail.  

 This nut attaches the rear trailing arm in 1980-91 Vanagons. Fits both 2WD and Syncro. Four per van, sold individually. Ref ID: N10105507

This sway bar end link to control arm bushing will fit all Syncro and fits 80 thru early 85 up to chassis number F 019682 2wd vans. 4 per van, sold separately. Ref ID: 251411039 Shop by Diagram Hover over the icon and click to get the detail.  

Fits 4WD & Early 2WD. This sway bar end link seat will fit all Syncro and also fits 80 thru early 85, up to chassis number F 019682. 4 per van, sold separately. Ref ID: 251411043 Shop by Diagram Hover over the icon and click to get the detail.  

Upper control arm washer. Fits all models, 2 per van- Sold separately. Please note that these are not the eccentric washers that are on the control arm bolts that are used to set camber adjustment for alignment but they are simply the washer that sits...

Replacing this front locking axle nut when you replace your rotor or wheel bearings is cheap insurance.  This nut is peened with a hammer and small punch during installation.  Repeated re-use of old nut weakens its shoulder, causing it to...

Rear control arm bolt washer. Fits all years and configurations of the VW T3 Vanagon. Eight washers per vehicle. Sold individually. Ref ID: 481501543

Upper control arm bolt eccentric washer. 6mm in width Sold individually Ref ID: 251407133D Shop by Diagram Hover over the icon and click to get the detail.  

Upper control arm bolt eccentric washer. 6.5mm in width Sold individually Ref ID: 251407133E Shop by Diagram Hover over the icon and click to get the detail.  

This is the eccentric washer used on the upper control arm for camber adjustment. Fits 2wd and 4wd Vanagons. 4mm in width. Sold individually Ref ID: 251407133A Shop by Diagram Hover over the icon and click to get the detail.