Fuel Fittings, Lines & Clamps

Quality pinch clamp pliers for Oetiker-style clamps. These are used to properly install full-circle 'ear'-style pinch clamps. This is absolutely a tool you should have in your toolbox.  We use Oetiker-style clamps on all our fuel-system...

Sold by the foot. 7.9mm Fuel line is the pressurized line for fuel delivery to and around the engine (30R14 rating rates the same as J30R9 with a new nylon interior barrier to prevent bio-diesel from soaking through). It is not the fuel line that is used...

Sold by the foot, this 6.3mm fuel line is used on the fuel tank breather/vapor system and replaces the original 5mm hose. It is not the fuel line that runs to the engine. Made by Gates. Ref ID: 27068

These are the smooth clamps (non-serrated) that we recommend using the rubber fuel line (not cloth). There are approx. 20 clamps if you are replacing all of the clamps for the pressurized lines. (This clamp is also the clamp we recommend using with our...

Excellent quality stainless steel pinch clamp. These are commonly used to seal the fuel expansion tank hoses to the plastic lines that run from fuel tank to expansion tank in your Vanagon. Note: these are Oetiker style pinch clamps.  You'll need a...

Stainless steel hose and tube clamp.  Commonly used in the VW T3 Vanagon to clamp the fuel vapor hoses which run from the fuel tank to the fuel expansion tanks in the front wheel wells.  Clamping range - 11.5-14.00 mmThis is an Oetiker-style...

This fuel clamp is used with the 5mm low pressure cloth fuel hose in the fuel tank breather system.  This is the small hose that travels to and from the fuel expansion tanks in 2WD and in the rollover valves in the Syncro. In 2WD Vanagons, there are...

This fuel line clamp is used in a couple short sections of the fuel lines in your VW Vanagon. In 2WD Vanagons with a 12mm outlet on their fuel tank, you'll use two of these clamps on the short hose between the tank and the fuel pump. In Syncro Vanagons,...