One-piece speedo cable for all 2WD/RWD Vanagon 1983 thru 91.

Earlier Vans use a threaded attachment to the back of the speedo and this is the later clip in style that started in 1983-ish.

This is a modern one-piece cable and will bypass the OXS counter box under your van.

To install:

• Disconnect the cable from the speedometer and tape the white pushbuttons together (that secure cable to speedo)
• Tie a nylon string to the taped end
• Remove your grille and driver side headlight assembly, which will gain access to the grommet where the cable runs through.
• Pull the upper portion of the old cable through the hole into the headlight area
• Detach the string from the cable but tie it off to the body for later use.
• Now tape the bottom of the new cable to the top of the old cable.
• Disconnect the cable from underneath at the wheel (best to remove the wheel bearing cap), and there also may be a bolt with a clip on the body.
• Now pull the old cable down through the floor with the new cable in tow. Route the new cable through the front end in the same manner
• Push it through the steering knuckle and into the wheel bearing cap.
• Now go back above and use string to pull the upper part of cable back up through dash.

VERY IMPORTANT: be sure to leave a little slack in cable in the dash area to allow the cable to have a sweeping arc as it enters the speedo head. The straighter it attaches and the smoother the arc, the less the likelihood of needle bounce.

Please Look: Look at the second picture and note the grommet is on the wrong side of the sheath. We occasionally receive cables that are not assembled correctly. Don't fret because this is an easy fix. First, pull the grommet off the cable from the circlip side (the part that goes to the hub). Then pull the white connector that goes to the speedo. Finally, install the grommet and put the connector back.

Ref ID: 251957803E