Heater

For older HS2000 and HS2800 heaters with the GHC252 circuit board. This is the 12V power harness that runs separate from the thermostat harness. Two-wire harness, two pin connector. You will need to wire a 5A inline fuse into the 12V+ wire to protect...

If the end cap on your HS2211 is damaged, we recommend replacement to keep your unit from dust contamination. New seal included!   Ref ID: 2986166

Propex silicone 90-degree elbow used to attach the combustion exhaust pipe in the HS2000 and HS2211 heater models.  The original connector is straight.  This optional 90-degree bend allows for routing the exhaust pipe with fewer bends...

Propex directional vent. This vent is used with either the 60mm (for HS2000) or 76mm (for HS2800) reducers to connect to the outlet ducting of the heater install. You would use this vent in the case that you want more than one vent in your...

Propex 12V power loom for HS2000 and HS2800 heaters manufactured after 2010. Fitment Notes: Approx. 11 feet in length Two wire, three-pin connector You will need to install a 5A inline fuse into the 12V power wire to protect your heater. Reinstalling a...

Propex 1/4"NPT to 1/4" NPT Compression Elbow For HS2211 models sold after May 2021 only. Ref ID: 2986172

26mm End Cap for HS2800 Combustion Piping This cap fits on the outboard end of the combustion piping for the HS2800 heater only Note:  these end caps were originally crimped at the Propex factory with special tooling.  If you are installing...

22mm End Cap for Combustion Exhaust - HS2000 - HS2211Fits these two heaters only! Note:  these end caps were originally crimped at the Propex factory with special tooling.  If you are installing this item on a metal 22mm flue pipe, you can make...

Replacement onboard fuse for current Propex heaters. When diagnosing issues with your heater, you can test whether your internal fuse is blown by listening for a brief spin up of the unit's fan when the power wire is disconnected and reconnected. If you...