Transmission

Factory roll pin that secures the shift selector lever to the shift selector shaft on the transmission. Removal of this pin is required to remove the lever when replacing the seal.   Fits 1983-1991 2WD and Syncro Vanagons with manual...

The vast majority of transmission fluid leaks off the side of the trans are from the flange cap (leaks into the CV) or drive axle seal (leaks down side of trans). On rare occasion the leak down the side of trans comes from this 0-ring which is behind...

This is the fastener for the plastic lock plate that locks the transmission sidescrew adjusting ring. Fits all manual transmission Vanagons including Syncro. Two per cap, four per van.  Sold individuallyAlso fits Type 2 bus 1968 thru 79. Ref ID:...

Auto transmission oil cooler seal. 4 per van, sold individually.Ref ID: 1039970045

This circlip secures the shift rod selector shaft.  It lives on the opposite side of the transmission case from the shift lever. Fits 1983.5-91 2wd & 4wd Vanagons with manual transmissions. Please click here for the shift rod selector shaft...

This circlip does double-duty in the Vanagon. It secures the speedometer cable to the wheel bearing cap on all 2WD Vanagons. It secures the shifter cable at the rear of the shift linkage on all Vanagons with automatic transmissions. Fits all 1980-91...

This is the universal shift joint o-ring for gear selector. Please click here for the circlip. Fits all Vanagon's with manual transmissions from mid-1983-91. Four per van, sold individually. Ref ID: N90089901 Shop by Diagram Hover over the icon and click...

This circlip pulls double duty in the Vanagon. It secures the hatch strut to the body of the van. It also holds the pins in the shift selector shaft to the shift linkage universal joint. Fits 1980-91. Sold individuallyRef ID: N0124362