Fuel Tank, Filler Neck & Cap

This fuel filler neck grommet sits in the side of the fuel tank and seals the fuel filler neck where it enters the tank. This grommet has a measurement of 57.5mm OD and 50mm ID. Fits all 1985-1991 2WD and Syncro models. (Also fits 1984 California...

This is the rubber buffer pad cushions your fuel tank where it makes contact with chassis.  Protect your tank with these quick and easy replacements. Fits 2WD only. There are two pads per side, four per van. Sold individually. Ref ID: 251201526

This fuel gauge sending unit o-ring fits all 2WD Vanagon models 1980-1991. This is the high-quality GERMAN o-ring rather than the generic aftermarket pieces available elsewhere.  The GERMAN o-ring is the ONLY one that we install here in the Van Cafe...

This fuel tank breather grommet is an essential component of the fuel tank breather system in your 2WD Vanagon.  There are three grommets used per van:  two for the crossover pipe on top of the tank and one for the filler neck vent tube. We...

This Tee connector is used when resealing the fuel system in your Vanagon. It is found: In the fuel line on the gas tank on your Syncro Between the plastic hoses on the fuel expansion tanks on all 2WD vans Ref ID: 113127563

This aftermarket fuel gauge sending unit o-ring fits all 2WD Vanagon models 1980-1991. This is an aftermarket seal black in color and is similar to the seal that comes with the sending unit. At Van Cafe, we prefer and recommend the original GERMAN...

These are the smooth clamps (non-serrated) that we recommend using the rubber fuel line (not cloth). There are approx. 20 clamps if you are replacing all of the clamps for the pressurized lines. (This clamp is also the clamp we recommend using with our...

This fuel clamp is used with the 5mm low pressure cloth fuel hose in the fuel tank breather system.  This is the small hose that travels to and from the fuel expansion tanks in 2WD and in the rollover valves in the Syncro. In 2WD Vanagons, there are...