Heater

Propex silicone 90-degree elbow used to attach the combustion exhaust pipe in the HS2000 and HS2211 heater models.  The original connector is straight.  This optional 90-degree bend allows for routing the exhaust pipe with fewer bends...

This Propex directional vent is used with either the 60mm (for HS2000) or 76mm (for HS2800) reducers to connect to the outlet ducting of the heater install. You would use this vent in the case that you want more than one vent in your installation. Use of...

These T-junctions screw directly into either the HS2211 outlet vents or accept all ducting found in HS2000 and HS2211 heater installations. Note:  When installing this junction we highly recommend installing the long straight top of the tee...

This Propex ducting Y-junction can be used to connect sections of 60mm ducting in installations of either the HS2000 or HS2211 heaters. The fitting measures 65mm in its inner diameter and the ducting simply slides into either end of the fitting.

Propex 12V power loom for HS2000 and HS2800 heaters manufactured after 2010. Fitment Notes: Approx. 11 feet in length Two wire, three-pin connector You will need to install a 5A inline fuse into the 12V power wire to protect your heater. Reinstalling a...

26mm End Cap for HS2800 Combustion Piping This cap fits on the outboard end of the combustion piping for the HS2800 heater only Note:  these end caps were originally crimped at the Propex factory with special tooling.  If you are installing...

22mm End Cap for Combustion Exhaust - HS2000 - HS2211Fits these two heaters only! Note:  these end caps were originally crimped at the Propex factory with special tooling.  If you are installing this item on a metal 22mm flue pipe, you can make...

Due to its unique design, the Propex HS2211 uses a different ducting system than the other Propex heaters.   These 65mm outlet vents screw directly into this straight connector.   The 60mm weatherproof ducting is then inserted into...