Fuel Fittings, Lines & Clamps

Everything you need to reseal the gas tank on your Syncro except for the fuel tank sending unit gasket. Includes: (1) Filler neck seal (2) Expansion tank grommets (2) Roll over float valves (1) Plastic vent tee (12-feet) 1/4" fuel line (3-feet) 12mm...

Replace your 32+ year-old plastic fuel rails with these billet aluminum fuel rails. Old plastic parts for the coolant or fuel system are the Achilles heel of your Vanagon. Plastic degrades over time, and it's not a question if it will fail, but when it...

Quality pinch clamp pliers for Oetiker-style clamps. These are used to properly install full-circle 'ear'-style pinch clamps. This is absolutely a tool you should have in your toolbox.  We use Oetiker-style clamps on all our fuel-system...

Sold by the foot. 7.9mm Fuel line is the pressurized line for fuel delivery to and around the engine (30R14 rating rates the same as J30R9 with a new nylon interior barrier to prevent bio-diesel from soaking through). It is not the fuel line that is used...

SOLD BY THE FOOT. 12mm fuel line runs from the tank to the pump. This is the feed line to the pump, it is not for a high-pressure location. 2 feet is the normal length required (in which case you would order quantity 2). Please note that a 2-foot length...

Sold by the foot, this 6.3mm fuel line is used on the fuel tank breather/vapor system and replaces the original 5mm hose. It is not the fuel line that runs to the engine. Made by Gates. Ref ID: 27068

These are the smooth clamps (non-serrated) that we recommend using the rubber fuel line (not cloth). There are approx. 20 clamps if you are replacing all of the clamps for the pressurized lines. (This clamp is also the clamp we recommend using with our...

Excellent quality stainless steel pinch clamp. These are commonly used to seal the fuel expansion tank hoses to the plastic lines that run from fuel tank to expansion tank in your Vanagon. Note: these are Oetiker style pinch clamps.  You'll need a...

Stainless steel hose and tube clamp.  Commonly used in the VW T3 Vanagon to clamp the fuel vapor hoses which run from the fuel tank to the fuel expansion tanks in the front wheel wells.  Clamping range - 11.5-14.00 mmThis is an Oetiker-style...

This fuel clamp is used with the 5mm low pressure cloth fuel hose in the fuel tank breather system.  This is the small hose that travels to and from the fuel expansion tanks in 2WD and in the rollover valves in the Syncro. In 2WD Vanagons, there are...

This fuel line clamp is used in a couple short sections of the fuel lines in your VW Vanagon. In 2WD Vanagons with a 12mm outlet on their fuel tank, you'll use two of these clamps on the short hose between the tank and the fuel pump. In Syncro Vanagons,...

This protective sleeve can help protect the 7mm (5/16") fuel lines in your Vanagon. Installation Note: Slide this sleeve over your new fuel hose and apply heat to the ends of the sleeve to keep the ends of the sleeve to keep them from fraying.  We...