Fuel Delivery

Accelerator cable retaining pin and bolt. This pin and bolt hold the accelerator cable to the accelerator lever pivot under the gas pedal. Fits both automatic and manual transmission vans including Syncro, diesels and air-cooled vans. Ref ID: 251721577

Aftermarket fuel pump mount. We finally found an alternative to the VW dealer expensive mounts. 2 per van. Sold individually.Also used for power steering hose mounts 2 per van. Ref ID: 113142355B-AFT Shop by Diagram Hover over the icon and click to...

Sold by the foot. 7.9mm Fuel line is the pressurized line for fuel delivery to and around the engine (30R14 rating rates the same as J30R9 with a new nylon interior barrier to prevent bio-diesel from soaking through). It is not the fuel line that is used...

Use this T connector when resealing the gas tank on your Syncro. It also fits all 2wd 80 thru 91 between the plastic hoses between the fuel expansion tanks. Original VW-made in plastic. Ref ID: 113127563

SOLD BY THE FOOT. 12mm fuel line runs from the tank to the pump. This is the feed line to the pump, it is not for a high-pressure location. 2 feet is the normal length required (in which case you would order quantity 2). Please note that a 2-foot length...

Sold by the foot, this 6.3mm fuel line is used on the fuel tank breather/vapor system and replaces the original 5mm hose. It is not the fuel line that runs to the engine. Made by Gates. Ref ID: 27068

These are the smooth clamps (non-serrated) that we recommend using the rubber fuel line (not cloth). There are approx. 20 clamps if you are replacing all of the clamps for the pressurized lines. (This clamp is also the clamp we recommend using with our...

Excellent quality stainless steel pinch clamp. These are commonly used to seal the fuel expansion tank hoses to the plastic lines that run from fuel tank to expansion tank in your Vanagon. Note: these are Oetiker style pinch clamps.  You'll need a...

Stainless steel hose and tube clamp.  Commonly used in the VW T3 Vanagon to clamp the fuel vapor hoses which run from the fuel tank to the fuel expansion tanks in the front wheel wells.  Clamping range - 11.5-14.00 mmThis is an Oetiker-style...