Engine Mechanical Components

Main bearing set for all 2.1Ltr engines. +.25mm (.010) on the crankshaft and standard on the case. Ref ID: 025198463A Shop by Diagram Hover over the icon and click to get the detail.  

This is the engine bracket that the motor mounts attach to. Fits all 2.1ltr engine 2wd and 4wd. Is also used on 1.9ltr engines when converting to the Rocky Mountain Westy stainless steel exhaust. Sold individually. Ref ID: 025199221A  

This is a high quality German engine gasket set for your Vanagon wasserboxer engine rebuild. The kit includes all seals and gaskets used during engine assembly and all gaskets and seals for components that touch the engine longblock. Note:  This kit...

Main bearing set for all 2.1ltr engines.  Standard size crank and standard case.   If your crankshaft hasn't been machined and your case hasn't been line bored, these are the bearings for you. Ref ID: 025198461A Shop by Diagram Hover over...

"IMPORTANT: This kit is for one side only. If you are doing both sides, order two. The kit includes head gasket, the two glues, one for the rubber head gasket, and one for the cap nuts for the cylinder head, and associated seals and gaskets. This kit is...

This distributor drive pinion gear runs off a brass gear on the engine crankshaft to turn the distributor rotor. Fits 1.9ltr & 2.1ltr vans Fun fact:  this pinion gear also fits Beetles from 1961-79, Ghia from 1961-74, Type 2 bus from 1960-71,...

This crankshaft timing gear drives the camshaft on 1.9Ltr &2.1Ltr watercooled motors. We recommend replacing this gear if yours exhibits any pitting or wear during an engine rebuild. Ref ID: 113105209

This brass distributor drive gear lives on the crankshaft.  It's made out of a softer metal than the distributor so it will wear rather than the distributor pinion.  Be sure to replace this at every engine rebuild. Fits all models of Vanagon...

New valve train push rod. Just in case yours gets bent. Please click here for the collaspeable push rod tube. Ref ID: 025109301 Shop by Diagram Hover over the icon and click to get the detail.  

These Mahle brand camshaft bearings are good quality at a reasonable price. Please note that there is an extra notch on the flanged bearings that you'll have to carefully file down flush before installing. Very easy operation. Ref ID: 025198541 Shop by...