Diff Lock Actuator

If your Syncro did not originally come with a differential lock, then you will need this kit to install our decoupler. Ref ID: VCVACKITDECOUPLER

These high quality European differential lock actuators are made by our partners in Germany. Fit 1986-1991 Syncros equipped with differential lockers. Diff-lock actuators usually go bad either because the diaphragm in them fails or the plastic nipples...

This differential lock actuator fork is what moves the locker from engaged to disengaged in your Syncro Vanagon.  Rebuilding your locker?  Consider replacing this fork.  

This is the "T"-shaped distribution component in the diff-lock actuator vacuum system.  If your differential lock is not activating or if it doesn't stay locked, consider a new vacuum "T" to seal the actuator system. Ref id: 251711861

This is the bracket that holds the vacuum manifold in place. Comes with the flat nut. Ref ID: 251711850

Locking diff. indicator switch. Not an original part but is a suitable alternative. Factory plug will need to be cut, and individual wire connectors will need to be used (and are included). Washer included too.Ref ID: KT-016941521

This stainless steel locking diff actuator bracket works for both rear and front locking differentials in the VW T3 Syncro.  It is equipped with mounting provisions that make it compatible with either a short or a long actuator shaft. Crafted from...

If your Syncro came with a front differential from the factory then your van uses this plunger. This plunger actuates when you pull and rotate the differential knob to lock the front diff. These do occasionally wear out with use.  If your front diff...

This vacuum hose supplies vacuum to the differential lock actuator on Syncro Vanagons that are equipped with diff locks. Fits 1986-91 Syncro Vanagons. Sold and priced per meter in continuous lenghts up to five meters. There may be a delay of 2 to 3 days...