Manual Transmission

Strap and plug for 80-91 air and watercooled, 2wd or 4wd, 4 or 5 speed, and used with diesel bell housing timing hole plug.  Ref ID #020301132

This is the washer for the plastic cap that bolts to the transmission case that locks the side screw adjusting ring into place.Fits all manual transmission Vanagons including Syncro. Also fits Type 2 bus 68 thru 79. 2 per cap, 4 per van.Ref ID: 113301195

This is the o-ring that goes between the transmission housing and the reverse light switch housing. Fits 83.5-onRef ID: 094301278A

Factory roll pin that secures the shift selector lever to the shift selector shaft on the transmission. Removal of this pin is required to remove the lever when replacing the seal.   Fits 1983-1991 2WD and Syncro Vanagons with manual...

The vast majority of transmission fluid leaks off the side of the trans are from the flange cap (leaks into the CV) or drive axle seal (leaks down side of trans). On rare occasion the leak down the side of trans comes from this 0-ring which is behind...

This is the fastener for the plastic lock plate that locks the transmission sidescrew adjusting ring. Fits all manual transmission Vanagons including Syncro. Two per cap, four per van.  Sold individuallyAlso fits Type 2 bus 1968 thru 79. Ref ID:...

This circlip secures the shift rod selector shaft.  It lives on the opposite side of the transmission case from the shift lever. Fits 1983.5-91 2wd & 4wd Vanagons with manual transmissions. Please click here for the shift rod selector shaft...

This is the universal shift joint o-ring for gear selector. Please click here for the circlip. Fits all Vanagon's with manual transmissions from mid-1983-91. Four per van, sold individually. Ref ID: N90089901 Shop by Diagram Hover over the icon and click...

This circlip pulls double duty in the Vanagon. It secures the hatch strut to the body of the van. It also holds the pins in the shift selector shaft to the shift linkage universal joint. Fits 1980-91. Sold individuallyRef ID: N0124362