Flywheel & Clutch

This transmission input shaft pilot bearing fits all Vanagons 1980-1991. This bearing is also included when you purchase a full clutch set. Please click here for the pilot bearing seal, and felt washer. Sold IndividuallyRef ID: 111105313A Shop by...

Clutch alignment tool for all stock Vanagon clutches.  This is the only way to get your clutch plate centered relative to the pressure plate when replacing your Vanagon clutch. Note:  These are also included in our complete clutch kits -...

This clutch pedal rebuild kit includes a new pin, bushing, and cotter pin. Please note that you will need to weld, grind and drill to use this kit. Please read through the instructions to determine whether you need to seek professional help...

Rubber bushing for the cross arm shaft in manual transmission Vanagons.   The cross arm shaft is what rotates in the bell housing to push the release (throwout) bearing into the clutch pressure plate.    Two per van.   If you...

This brass bushing supports the cross arm shaft in manual transmission vanagons.  The cross arm shaft is what rotates in the bell housing to push the release (throwout) bearing into the clutch pressure plate.    If you would like to...

This washer sits on the cross arm shaft in the bellhousing of manual transmission vans.  The cross arm shaft is what rotates in the bell housing to push the release (throwout) bearing into the clutch pressure plate.    If you would like...

This clevis pin attaches the pedal and brake pedal arms to their respective linkage assemblies.  This acts as a kind of pivot and so may be worn on your Vanagon.   Fits 1980-1991 2WD and Syncro Vanagons. Please click here for the clevis...

This clutch slave cylinder hose clip fits early Vanagons that use a rubber hose at the rear of the clutch pipe.  This is typically 1980 through chassis number 24-F-079099 (Mid-85) and early Syncros through 24-F-175000 (85). Fun fact:  Your...

This flywheel o-ring fits all 2.0Ltr aircooled and 1.9 & 2.1Ltr watercooled Vanagons from 1980-1991. One per Van. Also fits buses from 1972-1979. Ref ID: 021105279 Shop by Diagram Hover over the icon and click to get the detail.  

This lock nut locks in the free play adjustment for the clutch and brake pedal clevises. Fits 2WD and Syncro vanagons from 1980-91. One per pedal assembly, two per van. Sold individually Ref ID: N0111531

These bolts attach the flywheel or flex plate to the crankshaft. Five used per application, sold individually. If you need the flywheel o-ring, please click here. Ref ID: N90226801 Shop by Diagram Hover over the icon and click to get the detail.