Manual Transmission

Hey look!  Another specialty tool for your tool box! This 17MM Hex-head wrench is crucial for removing the drain and fill plugs on your Van's transmission.

Pack of two socket bearings required to rebuild the shifter base of all manual-transmission Vanagons.  These are also included in our complete shifter base rebuild kit. Shop by Diagram Hover over the icon and click to get the detail.  

Genuine VW shift fork guide ball sleeve.  There are six required for all manual transmission Vanagons. We HIGHLY recommend replacing these ball sleeves at each transmission rebuild as the slider ball bearing can fall into the transmission if this...

Fill plug for all manual & automatic transmissions. Uses 17mm allen wrench. Also for you Syncro owners this is the fill plug for the front diff as well. Don't forget this 17mm allen wrench for removal and replacement. Sold individually Ref ID:...

Early shift rod boot. Fits aircooled vans, 1980-83.4. This boot slides onto the rear gear linkage bearing pin/rod next to the transmission. Ref ID: 251711167A

Excellent quality main shaft needle bearing for all Vans with manual transmissions. Ref ID: 002311125A

Permatex ultra black oil resistant silicone gasket maker. On Syncros, we use this sealant for the decoupler, the bell housing gasket and if you are so inclined, the bell housing to engine case surfaces. The bell housing to the engine case surfaces came...

This is the plastic cap that bolts to the transmission case and locks the adjusting ring into place. Fits all manual transmission Vanagons including Syncro. Ref ID: 091301197

Guide ring for the rear gear linkage bearing pin/rod next to the transmission in aircooled and diesel Vanagons 1980-1983.4 -basically all models with the three-piece shift rod linkage. Please click here if you need a new shift rod pin. The pin comes with...