Transmission

This pressure spring lives on the accelerator rod at the transmission on all vans with an automatic transmission from 1980-1991 Ref ID: 010321319C

This washer/plate spreads the clamping force on the plastic cap located on the transmission behind the drive flanges.  The plastic cap locks the side screw adjusting ring into place. Fits all manual transmission Vanagons including Syncro. Also fits...

This Timing Hole Cap with Strap fits the hole in Bell Housing on all 1980-91 aircooled and watercooled Vanagons.  It's also used in conjunction with the diesel bell housing timing hole plug.  Ref ID #020301132

This plastic base for the Vanagon shifter is available individually, but is included in our complete shifter base kit. Shop by Diagram Hover over the icon and click to get the detail.   Ref ID: 171711227A

This is the washer that goes on the rear of the forward selector shaft in early vans with three shift rods going front to rear. Two per van. Aircooled and diesel vans 1980-1983.5. Ref ID: 171711965

This transmission side cover o-ring seals the side cover to the body of the transmission. We've found that the vast majority of transmission fluid leaks from the side of the trans are from the flange cap (leaks into the CV) or drive axle seal (leaks down...

This is the fastener for the plastic lock plate that locks the transmission sidescrew adjusting ring. Fits all manual transmission Vanagons including Syncro. Two per cap, four per van.  Sold individuallyAlso fits Type 2 bus 1968 thru 79. Ref ID:...

This circlip does double-duty in the Vanagon. It secures the speedometer cable to the wheel bearing cap on all 2WD Vanagons. It secures the shifter cable at the rear of the shift linkage on all Vanagons with automatic transmissions. Fits all 1980-91...