CV Axles & Components

Does your van suffer from a leaky rear axle seal that you just can't seem to tackle?  Use this sleeve to repair your worn cv axle!  If there is even slight wear on your cv axle where it rotates in the axle seal, the seal will no longer be able...

Redline CV-2 outperforms the best conventional or synthetic greases and lubes.Withstands extreme temperature and pressure in wheel bearings, U-joints, and high-angle CV Joints. Also great for use with Poly Urethane bushings. Excellent high-temp...

Our convenient CV bolt kit comes with everything you need to install an axle in your Vanagon. Our kit contains: (12) Hardened 12-point CV joint bolts (12) Serrated washers 12-point triple square socket for removing and installing VW CV bolts  This...

This excellent quality Rockford rear CV boot is thicker and far more durable than either the original or replacement boots on the market. Notes: Fits 1980-91 vanagons, also fits 1968-79 Bay window buses Fits all 2WD locations (four per van) Fits Syncro...

46MM tool to remove your rear axle nut on both 4WD and 2WD drive Vanagons. Best way to use this tool is slide it over the nut after removing the cotter pin and go at it with a sledgehammer to rotate it. Ref ID: 0057490 Shop by Diagram Hover over the icon...

This complete CV boot kit features high quality German made components. Kit includes: CV boot (6) 12-point CV bolts High quality CV grease Lock Ring CV clamp Consider upgrading to the Rockford boots here . If you need some serrated washers, please...

Redline CV-2 grease outperforms the best conventional or synthetic greases and lubes. Withstands extreme temperature and pressure in wheel bearings, U-joints, and high-angle CV Joints. Also great for use with Poly Urethane bushings. Excellent high-temp...

High strength hardware to install your CV axle. 12 bolts and 12 serrated washers Fits for both 2WD and 4WD axles 12-point triple-square bolts as original If replacing both axles, you'll need two bolt kits Please click here if you need the bolts,...

This 46mm rear axle nut is CRITICAL to the rear drivetrain of your van or bus! Without proper torque of 360 ft/lbs, this nut can come loose and ruin your day. Fits all Vanagon models 1980-91 Fits all bay window bus models 1968-71 Fits split window bus...

M8 triple square drive bit for 3/8" drive socket wrench. Please check your CV bolts before ordering as some vehicles can have 12 point bolts or 6-point bolts. Also sometimes referred to as a "triple-square bit". Please click here for the 12-point tool...

Six-point 6mm hex drive socket for use with aftermarket Vanagon CV bolts.   NOTE: Original CV bolts had 12-point socket heads.  We offer this tool to use if someone has replaced the original 12-point bolts with 6-point.  We feel that...