Propex Heaters & Parts

Propex 76mm APK ducting. Black. Weather-resistant.Sold by the meter. One meter is 3.28 feet or 39.3 inches.Appropriate for use with the HS2800 heater unit.Ducting for the HS2000 can be found here: https://www.vancafe.com/2986109-p/2986109.htm Please...

5 core loom (5 pin plug) - Suits the older HS2000/2800 heaters fitted with GHC252 circuit boards. Ref ID: 2986157

For older HS2000 and HS2800 heaters with the GHC252 circuit board. This is the 12V power harness that runs separate from the thermostat harness. Two-wire harness, two pin connector. You will need to wire a 5A inline fuse into the 12V+ wire to protect...

If the end cap on your HS2211 is damaged, we recommend replacement to keep your unit from dust contamination. New seal included!   Ref ID: 2986166

Propex silicone 90-degree elbow used to attach the combustion exhaust pipe in the HS2000 and HS2211 heater models.  The original connector is straight.  This optional 90-degree bend allows for routing the exhaust pipe with fewer bends...

Propex directional vent. This vent is used with either the 60mm (for HS2000) or 76mm (for HS2800) reducers to connect to the outlet ducting of the heater install. You would use this vent in the case that you want more than one vent in your...

Propex 12V power loom for HS2000 and HS2800 heaters manufactured after 2010. Fitment Notes: Approx. 11 feet in length Two wire, three-pin connector You will need to install a 5A inline fuse into the 12V power wire to protect your heater. Reinstalling a...

Propex 1/4"NPT to 1/4" NPT Compression Elbow For HS2211 models sold after May 2021 only. Ref ID: 2986172

26mm End Cap for HS2800 Combustion Piping This cap fits on the outboard end of the combustion piping for the HS2800 heater only Note:  these end caps were originally crimped at the Propex factory with special tooling.  If you are installing...