Go

1980-1983.4 T3 Vanagon

The Original! 1980 brought a complete redesign of the iconic VW bus from the ground up. Air-cooled Vanagons sport all the character of the T2 bay window bus coupled with all the safety and drivability upgrades of the T3 Vanagon. Van Cafe stocks quality replacement and upgrade parts for your 1980-1983 VW Vanagon.

Sidebar Sidebar Sidebar
  • Vanagon 7-Pin Electrical Connector (Male Side)
    Add to Cart The item has been added

    Vanagon 7-Pin Electrical Connector (Male Side)

    This seven-pin electrical connector is used on Vanagon engine and tail light harnesses in the engine compartment. This plug is often deformed by heat or brittle with age. This male side of the plug and comes complete with with new pins. The female side...
    $6.95
    SKU: 002917
    Add to Cart The item has been added
  • Window Chrome Molding Clip Window Chrome Molding Clip
    Add to Cart The item has been added

    Window Chrome Molding Clip

    This small clip finishes out the chrome molding that was originally installed on the windshield, side windows, and rear window of Vanagons at the factory.  These clips covers the ends of the chrome where they meet in the window seal. There is one...
    $6.95
    SKU: 001820
    Add to Cart The item has been added
  • Fuel Expansion Tank Grommet Fuel Expansion Tank Grommet
    Add to Cart The item has been added

    Fuel Expansion Tank Grommet

    This expansion tank grommet is an essential component of the fuel breather system.  It holds the rollover float valves in place and seals the fuel expansion tanks in 2WD Vanagons and the fuel tank in Syncros. It's essential that these are in good...
    $6.49
    SKU: 003567
    Add to Cart The item has been added
  • 19mm Sway Bar To End Link Bushing
    Add to Cart The item has been added

    19mm Sway Bar To End Link Bushing

    This rubber bushing connects the 19mm front sway bar to the end link. Sway bars came in both 19mm and 21mm sizes.  It's easy to check which size your van has by hopping under the front of your van with a 19mm open end wrench.  If the open end...
    $5.95
    SKU: 002059
    Add to Cart The item has been added
  • 21mm Sway Bar To End Link Bushing
    Add to Cart The item has been added

    21mm Sway Bar To End Link Bushing

    This rubber bushing connects the 21mm front sway bar to the end link. Sway bars came in both 19mm and 21mm sizes.  It's easy to check which size your van has by hopping under the front of your van with a 19mm open end wrench.  If the open end...
    $5.95
    SKU: 002058
    Add to Cart The item has been added
  • Clutch Alignment Tool
    Add to Cart The item has been added

    Clutch Alignment Tool

    Clutch alignment tool for all stock Vanagon clutches.  This is the only way to get your clutch plate centered relative to the pressure plate when replacing your Vanagon clutch. Note:  These are also included in our complete clutch kits -...
    $5.95
    SKU: 002799
    Add to Cart The item has been added
  • Clutch Pedal Rebuild Kit
    Add to Cart The item has been added

    Clutch Pedal Rebuild Kit

    This clutch pedal rebuild kit includes a new pin, bushing, and cotter pin. Please note that you will need to weld, grind and drill to use this kit. Please read through the instructions to determine whether you need to seek professional help...
    $5.95
    SKU: 004421
    Add to Cart The item has been added
  • Cross Arm Shaft Rubber Bushing
    Add to Cart The item has been added

    Cross Arm Shaft Rubber Bushing

    Rubber bushing for the cross arm shaft in manual transmission Vanagons.   The cross arm shaft is what rotates in the bell housing to push the release (throwout) bearing into the clutch pressure plate.    Two per van.   If you...
    $5.95
    SKU: 001721
    Add to Cart The item has been added
!