Load resistors for front turn signals with LED bulbs installed.

We all know the benefits to upgrading the exterior lighting of our Vans to LED. The bright, instant-on characteristics of LED couple nicely with the radically reduced current draw, leaving more juice for your accessories. Decreasing the current draw with LED turn signals may cause your turn signal relay to flash quickly or not at all. Van Cafe to the rescue!

We created these load resistors to install inline with your front turn signal bulbs. They are a simple plug and play installation - no tools or cutting of wires necessary. The resistors plug into the center and BL terminals of the bulb holder. We recommend plugging in the load resistors so that the new terminals face opposite directions. If you have trouble installing the bulb holder with one of the terminals on the outer rim, you can orient the resistor so that both terminals are facing inward, but you MUST then insulate the ground terminal from the van with electrical tape. There is a risk of metal to metal contact if you do not

NOTE: WE DESIGNED THESE TO WORK ON NORTH AMERICAN SPEC VANS. WE HAVE HAD REPORTS THAT THEY DO NOT WORK ON EURO OR AUSSIE SPEC VANS. IF YOUR FRONT TURN SIGNAL HAS A SINGLE FILAMENT BULB, YOU MAY STILL EXPERIENCE HYPERFLASH WITH THIS KIT.

This item includes (2) two LED front turn signal load resistors.

Ref ID: RMW-9981903